Accuracy:± 10 % or ±0.10 mg/L whichever is greater
Air purge:0.1 cfm at 20 psig
Alarm:Two alarms, selectable for sample concentration, system warning or system shutdown. Each alarm equipped with an SPDT relay with contacts rated for 5 A resisitive load at 230 Vac.
Calibration Method:5.0 mg/L fluoride standards
Compliance Certifications:CE approved, ETL listed to UL 1262, ETL certified to CSA 22.2 No. 142
Cycle Time:4.2 min
Dimensions (H x W x D):34.3 mm x 41.9 mm x 19.1 mm
Display:LCD, 3 to 1/2 -digit measurement readout and six-character alphanumeric scrolling
text line
Drain Fitting:1/2-inch ID flexible hose
Inlet:1/4-inch OD polyethylene tubing, quick-disconnect fitting
Inlet Pressure:1 to 10 psig (use sample restriction device
to reduce higher pressure samples)
Lower Limit of Detection (LOD):0.10 mg/L 0.10 ppm
Mounting:Wall mount
Operating Humidity:90 % at 40 °C
Operating temperature range:5 - 40 °C
Power requirements (Amps):2.5 A
Power requirements (Hz):50/60 Hz
Power requirements (Voltage):100 - 115/230 V AC
Power supply:selectable, 90 VA max. ,
Range:0.1 - 10.0 mg/L Fluoride
Recorder Outputs:An isolated output of the recorder, from 4 to 20 mA (can be set from 0 to 20 mA)
Sample Flow Rate:200
Sample Temperature:5 - 40°C (41 - 104°F)
Storage conditions:-40 to 60 °C (-40 to 140°F) without reagents